Research Article
Parameters Estimation and Curves Analysis for Faults Evaluation of a Degraded Photovoltaic Module
Issue:
Volume 13, Issue 4, December 2024
Pages:
67-81
Received:
1 October 2024
Accepted:
28 October 2024
Published:
18 November 2024
Abstract: In the present work, a fault evaluation method for photovoltaic arrays based on fault parameters identification and curves analysis is proposed for diagnosing the state of photovoltaic generators. An overview of the components, the modelling of the photovoltaic generator and the meaning of the parameters is established for relating parameters to photovoltaic components and environmental conditions. The analysis and investigation of the relationship between the maximum power points and the parameters variations are performed. Investigation on how degradations and failure on photovoltaic systems can affect parameters, is established. In this context, the methodology for diagnosing and monitoring defects based on photovoltaic estimated parameters is developed; the optimization technique maximum likelihood, is used for extracting health and faults parameters from the measured curves of the photovoltaic array. From residual vectors, the parameters which vary more are the series resistance, the shunt resistor, and the current of photon. The maximum power also changes and decreases from its reference value. The validation results prove deviations on parameters, which means that there are degradations and failures on the ARCO Solar M75 array after 20 years of outdoors operation. So, at the end of this analysis, it is recommended to act on the PV system through junction box, cell edges, wiring, busbars, and connectors.
Abstract: In the present work, a fault evaluation method for photovoltaic arrays based on fault parameters identification and curves analysis is proposed for diagnosing the state of photovoltaic generators. An overview of the components, the modelling of the photovoltaic generator and the meaning of the parameters is established for relating parameters to ph...
Show More
Research Article
Physicochemical Characterization and Production of Biodiesel from Cottonseed Oil and Waste Cooking Oil
Issue:
Volume 13, Issue 4, December 2024
Pages:
82-89
Received:
26 September 2024
Accepted:
21 October 2024
Published:
22 November 2024
DOI:
10.11648/j.ijrse.20241304.12
Downloads:
Views:
Abstract: Biodiesel is an eco-friendly, alternative diesel fuel prepared from domestic renewable resources i.e. mainly produced from vegetable oils and animal fats. It is a renewable energy source that appears to be the perfect answer to the world's energy needs, especially those of Ethiopia. The aim of present study was to evaluate the physicochemical characterization and production of biodiesel from cottonseed oil and waste cooking oil. Transesterification of edible and non-edible oil with methanol in the presence of strong acid or base catalysts is the standard process for creating biodiesel. The percent yield of cottonseed crude oil was found to be 62.98 % upon the extraction from the cotton seeds. After food residues and sediments were removed using chemical coagulation with 2% Al2SO4 as a coagulating agent and gravitational sedimentation, approximately 90.24 percent of the oil was recovered. The physicochemical parameters of oils and its biodiesel were performed and the experimental results such as moisture content (0.32% and 0.27%), specific gravity (0.86-0.9258), viscosity (4.1-65mm2/sec), saponification value (56.1-182.3 mg/g), Iodine value (51.74-120.53 mgI2/g), Acid value (0.30-0.50 mg/g), free fatty acid content ¬¬¬(0.23-1.9%), cetane number (74.6-137.56) and higher heat values (40.87-48.94 MJ/kg) are good agreement with ASTM standards. In conclusion, the result of recent study confirmed that the cottonseed oil and waste cooking oil derived biodiesel is an alternative renewable biofuel for petro-diesel with an eco-friendly.
Abstract: Biodiesel is an eco-friendly, alternative diesel fuel prepared from domestic renewable resources i.e. mainly produced from vegetable oils and animal fats. It is a renewable energy source that appears to be the perfect answer to the world's energy needs, especially those of Ethiopia. The aim of present study was to evaluate the physicochemical chara...
Show More
,
Deli Goron
